tag:blogger.com,1999:blog-4339813531032979196.post3377010777101091008..comments2024-02-28T07:32:59.864+00:00Comments on HydraRaptor: A day with PLAnopheadhttp://www.blogger.com/profile/12801535866788103677noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-4339813531032979196.post-34885639817366296532008-04-07T04:06:00.000+01:002008-04-07T04:06:00.000+01:00I've gone over to the GM17. I haven't, however, r...I've gone over to the GM17. I haven't, however, run it for enough hours to know if it represents a significant improvement over the 12v GM3, though.Forrest Higgshttps://www.blogger.com/profile/17208965471464716174noreply@blogger.comtag:blogger.com,1999:blog-4339813531032979196.post-58978392869363765032008-04-07T03:32:00.000+01:002008-04-07T03:32:00.000+01:00It seems like a good percentage of the problems we...It seems like a good percentage of the problems we've been seeing with extruding could be fixed by upgrading to a higher-powered motor. Is there a good reason to stick with the GM3? There's meatier alternatives out there that won't break the bank.Kyle Corbitthttps://www.blogger.com/profile/04573286825260180158noreply@blogger.comtag:blogger.com,1999:blog-4339813531032979196.post-27637278397916256002008-04-07T03:08:00.000+01:002008-04-07T03:08:00.000+01:00hmmm... so we have a range of roughly 4 times bet...hmmm... so we have a range of roughly 4 times between the least warping and the most warping plastic so far with the bottom being 0.15 mm over 20 mm.<BR/><BR/>Guess I'd better build that warpage model that I've been thinking about.Forrest Higgshttps://www.blogger.com/profile/17208965471464716174noreply@blogger.com