tag:blogger.com,1999:blog-4339813531032979196.post3057915908843087914..comments2024-02-28T07:32:59.864+00:00Comments on HydraRaptor: ESP8266 contention during programming nopheadhttp://www.blogger.com/profile/12801535866788103677noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-4339813531032979196.post-43241858793947266312018-04-26T18:19:39.511+01:002018-04-26T18:19:39.511+01:00Yes 10K to ground would put it into programming mo...Yes 10K to ground would put it into programming mode. Normally this would be via a switch with a pull up so it runs when the switch is not pressed or connected to DTR for auto programming. Again with a pull up so when the programmer is disconnected it runs.<br /><br />nopheadhttps://www.blogger.com/profile/12801535866788103677noreply@blogger.comtag:blogger.com,1999:blog-4339813531032979196.post-35641712400802621762018-04-26T17:32:47.636+01:002018-04-26T17:32:47.636+01:00Can you confirm that the value to use is 10K betwe...Can you confirm that the value to use is 10K between GPIO0 and ground?James Newtonhttps://www.blogger.com/profile/12037091869641832295noreply@blogger.com