tag:blogger.com,1999:blog-4339813531032979196.post1758609700337235007..comments2024-02-28T07:32:59.864+00:00Comments on HydraRaptor: Melzi modnopheadhttp://www.blogger.com/profile/12801535866788103677noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-4339813531032979196.post-12040318135042721082013-01-17T22:23:43.049+00:002013-01-17T22:23:43.049+00:00Yes my kits ship with those resistors replaced wit...Yes my kits ship with those resistors replaced with 0R links.nopheadhttps://www.blogger.com/profile/12801535866788103677noreply@blogger.comtag:blogger.com,1999:blog-4339813531032979196.post-30623243040347359822013-01-17T22:15:45.570+00:002013-01-17T22:15:45.570+00:00It is now 2013 - Have you tested your Resistor mod...It is now 2013 - Have you tested your Resistor mod to the A4988 and incorporated into your kits?BAShttps://www.blogger.com/profile/11712266694307971483noreply@blogger.comtag:blogger.com,1999:blog-4339813531032979196.post-54402038577225548122012-08-01T01:34:39.230+01:002012-08-01T01:34:39.230+01:00You can't do it with the older Pololus with th...You can't do it with the older Pololus with the A4983 chip but you can with the A4988. I have done it to mine. The only downside seems to be a bit more noise when stationary.<br /><br />I suspect it might cause better print quality through smoother motion rather than the extra resolution. I will do some tests.nopheadhttps://www.blogger.com/profile/12801535866788103677noreply@blogger.comtag:blogger.com,1999:blog-4339813531032979196.post-59365657989006224792012-08-01T00:08:28.400+01:002012-08-01T00:08:28.400+01:00Do you recommend doing this with standard Pololus ...Do you recommend doing this with standard Pololus for the typical low voltage RepRap stepper motor? Also, is the effect on printing noticeable?Cameronhttps://www.blogger.com/profile/11677688204387541908noreply@blogger.com